HEIDENHAIN CNC PILOT 640 - Page 644

TURN PLUS | Example
7
644
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Defining the basic contour
Defining the basic contour:
Select the ICP menu item
Select the Finished part menu item
Select the Contour menu item
Enter start point of the contour XS = 0, ZS = 0
and end point of the element X = 16
Press the Save soft key
Enter Z = –25
Press the Save soft key
Enter X = 35
Press the Save soft key
Enter Z = -43
Press the Save soft key
Enter X = 58, AN = 70
Press the Save soft key
Enter Z = -76
Press the Save soft key
Enter X = 0
Press the Save soft key
Press the Back soft key