TURN PLUS | Example
7
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
645
Defining form elements
Defining chamfer at Corner:
Select the form elements.
Select Cham
Select the desired corner
Press the Select soft key
In the Cham dialog box: Enter Chamfer width =
3 mm
Press the Save soft key
Rounding arcs:
Select Rounding
Select the desired corner
Select further corners if required
Press the Select soft key
In the Rounding dialog box: Enter Rounding
radius = 2 mm
Press the Save soft key
To Next Page
Loading...
