TURN PLUS | Example
7
646
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Undercut:
Select Undercut
Select menu item Undercut type
Select the desired corner
Press the Select soft key
TURN PLUS opens the Undercut DIN 76 dialog
box
The undercuts are already saved in the control.
Press the Save soft key
Recess:
Select Recess
Select the Recess standard / G22 menu item
Select the desired corner
Press the Select soft key
In the Recess standard / G22 dialog box: Enter
the values
Destinat. point X = –38 mm
Inner corner I = 27 mm
Inner corner Ki = 8 mm
Outs.rad./cham. B = –1 mm
Press the Save soft key
To Next Page
Loading...
