HEIDENHAIN CNC PILOT 640 - Engraving in XY Plane G803

DIN/ISO Programming for the Y axis | Milling cycles for the Y axis
6
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
605
Engraving in XY plane G803
G803 engraves character strings aligned linearly in the XY plane.
Further information: "Character sets", Page 433
The cycles start engraving from the starting position or from the
current position, if no starting position is defined.
Example: If a character string is engraved with several calls, define
the starting position in the first call. All other calls are programmed
without a starting position.
Parameters:
X, Y: Start point
Z: Final point – Z position, infeed depth during milling
RB: Return plane – Z position retracted to for positioning
ID: Text to be engraved
NF: Char. no. – ASCII code of the character to be engraved
W: Inclinat. ang. of the character string
Example: 0° = vertical characters: The characters are aligned in
sequence in positive X direction
H: Font height
E: Distance factor (calculation: see figure)
The distance between the characters is calculated according to
the following formula: H / 6 * E
F: Plunging feed rate factor (plunging feed rate = current feed
rate * F)
O: Mirror writing
0 (No): Engraving is not mirrored
1 (Yes): Engraving is mirrored (mirror writing)