DIN/ISO programming | Other G codes
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
443
Convert lengths G927
Function G927 is used to convert the tool lengths at the current tool
insert angle to the initial position of the tool (reference position in B
axis = 0).
The results can be interrogated in the variables #n927( X), #n927( Z)
and #n927( Y).
Parameters:
H: Type of calculation
0: Convert tool length to reference position (take I + K of the
tool into account)
1: Convert tool length to reference position (do not take I + K
of the tool into account)
2: Convert tool length from the reference position to the
current work position (take I + K of the tool into account)
3: Convert tool length from the reference position to the
current work position (do not take I + K of the tool into
account)
X, Y, Z: Axis values (X value = radius; If nothing is entered, the
value 0 is used)
To Next Page
Loading...
