HEIDENHAIN CNC PILOT 640 - Constant Feed G94 (Feed Per Minute); Feed Per Tooth Gx93

DIN/ISO programming | Feed rate, shaft speed
4
298
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Feed per tooth Gx93
Gx93 (x: spindle 1...3) defines the drive-dependent feed rate with
respect to the number of teeth of the cutter.
Parameters:
F: Feed per tooth in mm/tooth or inch/tooth
The actual value display shows the feed rate in mm/rev.
Example: G193
. . .
N1 M5
N2 T1 G197 S1010 G193 F0.08 M104
N3 M14
N4 G152 C30
N5 G110 C0
N6 G0 X122 Z-50
N7 G...
N8 G...
N9 M15
. . .
Constant feed G94 (feed per minute)
G94 defines the feed rate independent of drive.
Parameters:
F: Feed per min in mm/min or inch/min
Example: G94
. . .
N1 G14 Q0
N2 T3 G94 F2000 G97 S1000 M3
N3 G0 X100 Z2
N4 G1 Z-50
. . .