DIN/ISO programming | Other G codes
4
450
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Activating direct program-run continuation G999
With the G999 function, when running a program in Single Block
mode, the following NC blocks are run with a single NC start to the
end of the program. G999 is then deactivated by again calling the
function with the setting Q0 (off).
Force reduction G925
Refer to your machine manual.
The machine tool builder determines the scope of
function and behavior of this function.
G925 activates/deactivates the force reduction. When monitoring
is activated, the maximum Contact force for one axis is defined.
Force reduction can be activated for only one axis per NC channel.
The G925 function limits the Contact force for subsequent
movements of the defined axis. G925 does not execute any
traverse movements.
Parameters:
H: Contact force in daN – the contact force is limited to the
value entered
Q: Axis number (X = 1, Y = 2, Z = 3, U = 4, V = 5, W = 6, A =
7, B = 8, C = 9) No. of spindle, e.g. spindle 0 = number 10 (0 =
10, 1 = 11, 2 = 12, 3 = 13, 4 = 14, 5 = 15)
P: Sleeve monitoring on/off
0: Deactivate (contact force is not monitored)
1: Activate (contact force is monitored)
Lag error monitoring is not activated until the
acceleration phase has been completed.
To Next Page
Loading...
