HEIDENHAIN CNC PILOT 640 - Polygon on Front;Rear Face G307-Geo; Rectangle on Front;Rear Face G305-Geo

DIN/ISO programming | Front/Rear face contours
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
281
Rectangle on front/rear face G305-Geo
G305 defines a rectangle in a contour on the front face/rear face.
Parameters:
XK: Center (Cartesian)
YK: Center (Cartesian)
X: Diameter – Center (polar)
C: Angle – Center (polar)
A: Angle to XK axis (default: 0°)
K: Length of rectangle
B: Height of rectangle
R: Chamf./round. (default: 0)
R > 0: Radius of rounding arc
R < 0: Chamfer width
P: Depth/Height (default: P from G308)
P < 0: Pocket
P > 0: Island
Polygon on front/rear face G307-Geo
G307 defines a polygon in a contour on the front face/rear face.
Parameters:
XK: Center (Cartesian)
YK: Center (Cartesian)
X: Diameter – Center (polar)
C: Angle – Center (polar)
A: Angle to XK axis (default: 0°)
Q: Number edges
K: +edge lngth/-width a. flats
K > 0: Edge length
K < 0: Width across (Inside diameter)
R: Chamf./round. (default: 0)
R > 0: Radius of rounding arc
R < 0: Chamfer width
P: Depth/Height (default: P from G308)
P < 0: Pocket
P > 0: Island