smart.Turn units for the Y axis | Units – Milling in Y axis
3
228
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Engraving, YZ plane unit
The unit engraves character strings aligned linearly in the YZ
plane. Diacritics and special characters that you cannot enter in
smart.Turn operating mode can be defined, character by character,
in NF. If you program Q = 1 (Continue from last text) tool change
and pre-positioning are suppressed. The technological data of the
previous engraving cycle apply.
Unit name: G804_GRA_Y_MANT / cycle: G804
Further information: "Engraving in YZ plane G804", Page 606
Position form:
Y, Z: Start point
X: Final point – X position, infeed depth during milling (diameter
value)
RB: Return plane
Cycle form:
TXT: Text to be engraved
NF: Char. no. – ASCII code of the character to be engraved
H: Font height
E: Distance factor (calculation: see figure)
The distance between the characters is calculated according to
the following formula: H / 6 * E
W: Inclinat. ang. of the character string
FZ: Plunging feed rate factor (plunging feed rate = current feed
rate * FZ)
Q: Continue from last text
0 (No): Engraving starts at the starting point
1 (Yes): Engraving starts at the tool position
O: Mirror writing
0 (No): Engraving is not mirrored
1 (Yes): Engraving is mirrored (mirror writing)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: Engraving
Affected parameters: F, S
To Next Page
Loading...
