smart.Turn units | Units – Special operations
2
200
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Program end unit
In every smart.Turn program, the end unit should be called once at
the end of the machining section.
Unit name: END / Called cycle: None
Program end form:
ME: Type of return jump:
30: Without restart M30
99: With restart M99
NS: Block no. for return jump
G14: Tool change point
No axis
0: Simultaneously
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y (machine-dependent)
6: Simultaneous w/ Y (machine-dependent)
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
To Next Page
Loading...
