DIN/ISO programming | Engraving cycles
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
433
4.27 Engraving cycles
Character sets
The control can realize the characters listed in the following table. The
text to be engraved is entered as a character string. Diacritics and
special characters that you cannot enter in the editor can be defined,
character by character, in NF. If text is defined in ID and a character is
defined in NF, the text is engraved before the character.
You can also use the engraving cycles to engrave string variables. In
ID, enter the variable to be engraved using the Variables soft key.
Further information: "Variable types", Page 461
To Next Page
Loading...
