NC programming | Fundamentals: smart.Turn editor
1
52
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
ICP menu item
The ICP (Interactive Contour Programming) menu item contains the
following functions:
Contour editing: Change the current contour (cursor position)
Workpiece blank: Edit the description of the workpiece blank
Finished part: Edit the description of the finished part
New auxiliary blank: Create a new auxiliary blank
New aux. contour: Create a new auxiliary contour
C axis: Create patterns and milling contours on the front face
and lateral surface
Y axis: Create patterns and milling contours in the XY and YZ
planes
Insert contour: Insert saved workpiece blank contour and
finished part contour (only active if you have already saved a
contour via the Simulation submode)
Go to menu item
The Go to menu item contains the following jump and search
functions:
Jump targets—The editor positions the cursor to the selected
jump target:
To beginning
To turret list (To tool table)
To finished part
To machining
To end
Search functions
Find block number… Ctrl+G: You specify a certain block
number. The editor jumps to this block number if it exists
Find unit… Ctrl+U: The editor opens the list of units
available in the program. Select the desired unit
Find NC word… Ctrl+F: The editor opens the dialog for
entering the desired NC word. You can use the soft keys to
search forward or backward
Search for contour…: The editor opens the list of contours
available in the program. Select the desired contour
To Next Page
Loading...
