smart.Turn units | Units – Special operations
2
196
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Defaults form:
GWW: Tool change point
No axis (do not approach the tool change point)
0: Simultaneously X and Z axis depart diagonally
1: First X, then Z
2: First Z, then X
3: Only X
4: Only Z
5: Only Y
6: Simultaneous w/ Y
CLT: Coolant
0: Without
1: Coolant 1 on
2: Coolant 2 on
G60: Deactivate Protection zone for the drilling operation
0: Active
1: Inactive
Cycle form:
L: Subprogram - Name – name of a subprogram that is called by
the start unit
Global form:
G47: Safety clearance
SCK: Safety clearance in infeed direction during drilling and
milling operations
SCI: Safety clearance in the machining plane during drilling and
milling operations
I, K: O-size X and Z
To Next Page
Loading...
