HEIDENHAIN CNC PILOT 640 - Page 21

Contents
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
21
2.6 Units – Predrilling in C axis.............................................................................................................. 137
Predrilling, contour milling, figures unit............................................................................................... 137
Predrilling, pocket milling, figures, face unit........................................................................................139
Predrilling, contour milling, ICP, face unit............................................................................................ 141
Predrilling, pocket milling, ICP, face unit..............................................................................................142
Predrilling, contour milling, figures, lateral surface unit.......................................................................143
Predrilling, pocket milling, figures, lateral surface unit........................................................................ 145
Predrilling, contour milling, ICP, lateral surface unit.............................................................................147
Predrilling, pocket milling, ICP, lateral surface unit.............................................................................. 149
2.7 Units – Finishing................................................................................................................................ 150
ICP contour machining – ICP finishing unit......................................................................................... 150
Contour machining, direct longitudinal – finishing longitudinal with direct contour input unit..............153
Contour machining, direct transverse – finishing transverse with direct contour input unit................ 155
Undercut form E, F, DIN76 unit........................................................................................................... 157
Measuring cut unit...............................................................................................................................159
2.8 Units – Threads.................................................................................................................................. 160
Overview of thread units..................................................................................................................... 160
Handwheel superimposition................................................................................................................ 160
Parameter V: Type of infeed................................................................................................................ 161
Thread, direct unit................................................................................................................................162
ICP thread unit..................................................................................................................................... 164
API thread unit..................................................................................................................................... 166
Tapered thread unit.............................................................................................................................. 167
2.9 Units – milling, face (C axis).............................................................................................................169
Slot, face unit.......................................................................................................................................169
Linear slot pattern, face unit................................................................................................................170
Circular slot pattern, face unit..............................................................................................................171
Face milling unit...................................................................................................................................172
Thread milling unit................................................................................................................................173
Contour milling, figures, face unit....................................................................................................... 174
Pocket milling, figures, face unit..........................................................................................................176
Engraving, face unit............................................................................................................................. 178
ICP contour milling, face unit.............................................................................................................. 179
ICP pocket milling, face unit................................................................................................................180
Deburring, face unit............................................................................................................................. 181
ICP face milling unit.............................................................................................................................182
2.10 Units – milling, lateral surface (C axis)............................................................................................183
Slot, lateral surface unit....................................................................................................................... 183
Linear slot pattern, lateral surface unit................................................................................................ 184
Circular slot pattern, lateral surface unit..............................................................................................185
..............................................................................................................................................................186
Contour milling, figures, lateral surface unit........................................................................................187