HEIDENHAIN CNC PILOT 640 - Page 405

DIN/ISO programming | Milling cycles
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
405
Contour definitions in the machining section (figures):
Face
G301 Linear slot
Further information: "Linear slot on front/rear face G301-
Geo", Page 279
G302/G303 Circular slot
Further information: "Circular slot on front/rear face G302-/
G303-Geo", Page 280
G304 Full circle
Further information: "Full circle on front/rear face G304-Geo",
Page 280
G305 Rectangle
Further information: "Rectangle on front/rear face G305-
Geo", Page 281
G307 Eccentric polygon
Further information: "Polygon on front/rear face G307-Geo",
Page 281
Lateral surface
G311 Linear slot
Further information: "Linear slot on lateral surface G311-Geo",
Page 286
G312/G313 Circular slot
Further information: "Circular slot on lateral surface G312-/
G313-Geo", Page 287
G314 Full circle
Further information: "Full circle on lateral surface G314-Geo",
Page 287
G315 Rectangle
Further information: "Rectangle, surface G315-Geo",
Page 288
G317 Eccentric polygon
Further information: "Polygon on lateral surface G317-Geo",
Page 288