DIN/ISO programming | Milling cycles
4
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
417
G840 – calculating hole positions
G840 A1 .. calculates the hole positions and stores them at the
reference specified in NF. Program only the parameters given in the
following table.
See also:
G840—Fundamentals
Further information: "G840 – fundamentals", Page 416
G840—Milling
Further information: "G840 – milling", Page 419
Parameters:
Q: Cycle type – milling location
Open contour. If there is any overlapping, Q defines whether
the first section (as of starting point) or the entire contour is to
be machined
Q = 0: Center of milling cutter on the contour (hole position
= starting point)
Q = 1: Machining at the left of the contour. If there is any
overlapping, only the first area of the contour is machined
Q = 2: Machining at the right of the contour. If there is any
overlapping, only the first area of the contour is machined
Q = 3: Not allowed
Q = 4: Machining at the left of the contour. If there is any
overlapping, the entire contour is machined
Q = 5: Machining at the right of the contour. If there is any
overlapping, the entire contour is machined
Closed contours
Q = 0: Center of milling cutter on the contour (hole position
= starting point)
Q = 1: Inside milling
Q = 2: Outside milling
Q = 3 to 5: Not allowed
ID: Milling contour – name of the milling contour
NS: Starting block no. of contour – beginning of contour section
Figures: Block number of the figure
Free closed contour: First contour element (not starting point)
Open contour: First contour element (not starting point)
To Next Page
Loading...
