HEIDENHAIN CNC PILOT 640 - Page 526

Touch probe cycles | Touch probe cycles for single-point measurement
5
526
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
H: INPUT instead of measure
0: Standard – obtain measured values by probing
1: PC test – simulate touch probe cycle on the programming
station
AN: Log no. – save measurement results in the
TNC:\table\messpro.mep table (line numbers 0-99)
The table can be expanded if necessary.
Example: G771 Single-point measurmnt., datum
. . .
MACHINING
N3 G771 R1 D0 K20 AC0 BD0.2 Q0 P0 H0
. . .