HEIDENHAIN CNC PILOT 640 - Page 530

Touch probe cycles | Touch probe cycles for single-point measurement
5
530
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Q: Tool orientation (machine-dependent)
Orient the touch probe in the programmed probing direction
before each probing operation.
P: PRINT outputs
0: OFF – do not display measuring results
1: ON – display measuring results on the screen
H: INPUT instead of measure
0: Standard – obtain measured values by probing
1: PC test – simulate touch probe cycle on the programming
station
AN: Log no. – save measurement results in the
TNC:\table\messpro.mep table (line numbers 0-99)
The table can be expanded if necessary.
Example: G773 Single-point measurement C-axis object center
. . .
MACHINING
N3 G773 R1 C20 E0 RB20 RC45 AC30 BD0.2 Q0P0 H0
. . .