NC programming | Program section code
1
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
59
Meaning DINplus word Description
Auxiliary contour Auxiliary contour
Page 64
Aux. workpiece
blank
AUX. BLANK
Page 64
C-axis contours
Front FRONT
Page 65
REAR SIDE REAR SIDE
Page 65
Lateral LATERAL
Page 65
Y-axis contours
Face Y Face Y
Page 65
REAR SIDE Y REAR SIDE Y
Page 65
Lateral surface in Y Lateral surface in Y
Page 66
Workpiece machining
Machining operation MACHINING
Page 68
End END
Page 68
Subprograms
Subprogram SUBROUTINE
Page 68
Return Return
Page 68
Others
CONST CONST
Page 68
VAR VAR
Page 69
SLIDE ALLOCATION SLIDE ALLOCATION
"SLIDE
ALLOCATION
code"
If there is more than one independent contour definition
for drilling and milling, use the program section codes
(FRONT, LATERAL, etc.) each time.
To Next Page
Loading...
