DIN/ISO Programming for the Y axis | Milling cycles for the Y axis
6
602
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Cycle run:
1
Start position (X, Y, Z, C) is the position before the cycle begins
2 Calculates the number of cuts (infeeds to the milling planes,
infeeds in the milling depths) and the plunging positions and
paths for reciprocating or helical plunges.
3
Approaches to safety clearance and, depending on O, feeds
to the first milling depth or approaches helically or on a
reciprocating path
4 Mill the first plane.
5 Retract by the safety clearance, return and cut to the next
milling depth.
6 Repeat steps 4 and 5 until the complete area is milled.
7
Returns to Return plane RB
To Next Page
Loading...
