TURN PLUS | Automatic working plan generation (AWG) submode
7
624
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Editing a Machining sequence:
Position the cursor
Select TURN PLUS
Select Line
Select the function.
Inserting a new machining operation
Moving a machining operation
Editing the machining sequence
Deleting a machining operation
Inserting a new machining operation:
Select Insert above the line to insert a new
machining operation before the cursor position
Select To insert below the line, press Insert to
insert a new machining operation after the cursor
position
Moving a machining operation:
Select Move line upwards
Alternative: Select Move line downwards
Editing the machining sequence:
Select Edit Line Enter
Press the OK soft key
Deleting a machining operation:
Select Delete line
To Next Page
Loading...
