B axis | Simulation
8
660
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
Example: Contour in tilted plane
...
FINISHED PART
N2 G0 X0 Z0
N3 G1 X50
N4 G1 Z–50
N5 G1 X0
N6 G1 Z0
SURFACE Y X50 C0 B80 I25 K-10 H0
N7 G386 Z0 Ki10 B–30 X50 C0
Single surface
SURFACE Y X50 C0 B20 I25 K-20 H1
N8 G384 Z–10 Y10 X50 R10 P5
Full circle
...
Displaying the coordinate system
The simulation can show the shifted/rotated coordinate system in
the lathe window if required.
To use this feature, you need to stop the simulation.
Displaying the coordinate system:
Press the -/+ key
The simulation displays the current coordinate
system
The coordinate system disappears when the next command is
simulated or when you press the -/+ key once again.
Position display with the B and Y axes
The following boxes of the display cannot be edited:
N: Block number of the NC source block
X, Z, C: Position values (actual values)
The other boxes can be set with the Split-Screen Layout key
(three arrows arranged in a circle):
Default settings (values of the selected slide)
Y: Position value (actual value)
T: Tool data with turret pocket, (in "(..)") and ID no.
B axis settings
B: Tilt angle of the B axis
G16/B: Angle of the tilted plane
To Next Page
Loading...
