Appendix
BAT54-Rail/F..
Release
7.54
06/08
13.1
Error messages in LANmonitor
521
Dynamic VPN - preset time limit
exceeded
x
The time limit under "Configure --> Costs -->
Time limit (ISDN)" was reached. Please reboot
the device.
Dynamic VPN - no ISDN call
number for negotiator channel
x
The ISDN call number for the remote device for
dynamic VPN is missing. Please enter the call
number under "Configure --> Communication -->
Remote sites --> Name list (ISDN) --> Name".
Dynamic VPN - Multiple connec-
tions on ISDN interface for negoti-
ator channel not allowed
While establishing multiple ISDN connections, a
limit was reached. Please check under "Config-
ure --> Management --> Interfaces --> Interface
Settings --> ISDN --> Max. outgoing calls".
Predefined charging limit
exceeded
x
The fee limit under "Configure --> Management -
-> Costs --> Charge limit (ISDN)" was reached.
Indicated by a synchronized blinking of the
Power LED.
Predefined time limit exceeded
x
The time limit under "Configure --> Management
--> Costs --> Time Limit (ISDN)" was reached.
Indicated by a synchronized blinking of the
Power LED.
No IP address for PPTP server
x
The IP address of the PPTP selected has not
been entered. Enter the IP address under "Con-
figure --> Communication --> Protocols -->
PPTP list". Also see .
Exchange type mismatch (Main or
Aggressive mode)
x (IKE)
The exchange type does not match that of the
remote device. Please check the value under
"Configure --> VPN --> Connection list --> Edit
VPN remote site entry --> IKE Exchange"
No proposal matched
x (IKE)
The IKE proposals do not match. -- > Check
VPN rules
No proposal matched
x (IKE)
The IKE proposals do not match. -- > Check
VPN rules
IKE group mismatch
x (IKE)
Please check the IKE groups on both sides
under "Configure --> VPN --> Connection
parameters --> VPN remote site identification -->
IKE Group"
Life type unsupported (other than
Kbytes or seconds?)
x (IKE)
The value for the lifetime is not supported.
Please use a life type in "sec = seconds" or "kb =
kilobytes". Check this entry under "Configure -->
VPN --> Parameters --> Lifetime"
Lifetime mismatched
x (IKE)
The lifetime specified does not match that of the
remote device. Check this entry under "Config-
ure --> VPN --> Parameters --> Lifetime"
ID type value unsupported (other
than IP network, domain, or
email)
x (IKE)
False entry of identity. Please correct your entry
under "Configure --> VPN --> IKE --> IKE key"
ID type mismatch (e.g. IP net-
work, domain, or email)
x (IKE)
The two sites are using different identities. Com-
pare the identification at both sites under "Con-
figure --> VPN --> IKE --> IKE key"
No rule matched ID - unknown
connection or wrong ID (e.g.
remote gateway definition)
x (IKE)
The incoming VPN connection could not be
assigned to a remote device.
IKE key mismatch
x (IKE)
Please compare the preshared keys under
"Configure --> VPN --> IKE --> IKE key"
IKE key mismatch
x (IKE)
Please compare the preshared keys under
"Configure --> VPN --> IKE --> IKE key"
Message Initiator Responder
To Next Page
