Honeywell GNS-XLS - Direct to - Hp Waypoint; To Cancel Holding Pattern:(from the Holding Pattern Page); To Select and Go Direct to HP Waypoint

System Operation
3-52
GNS-XLS Flight Management System
Rev. 3
Sep/96
DIRECT TO - HP WAYPOINT
1. d Key - DEPRESS. A DIRECT TO Page appears with the
cursor over the current TO waypoint.
2. Line Select Key - DEPRESS to position the cursor over the
desired HP identifier. (Figure 3-89)
NOTE: Active Flight Plans
exceeding 18 waypoints will
be continued on subsequent
pages. Press d , NXT or
PRV Key to access remain-
ing waypoints.
3. ENTER Key - DEPRESS
to display the HOLDING
PATTERN Page with
both the OK? ENTER
and CANCEL option.
(Figure 3-90)
NOTE: The holding pattern
may be edited if required , at
this time. See Page 3-67 for
details.
To Select and Go Direct
To HP Waypoint:
4. ENTER Key - DEPRESS.
Display automatically
advances to NAVIGA-
TION Page 1.
5. DIS, DTK - CHECK.
To Cancel Holding Pattern:(from the Holding Pattern page)
1. Line Select - DEPRESS to position cursor over desired HP way-
point.
2. Hold Key - DEPRESS
3. Line Select Key - DEPRESS to position the cursor over CANCEL?.
4. ENTER Key - DEPRESS. Display automatically advances to
NAVIGATION Page 1 and aircraft proceeds Direct To the way-
point with the Holding Pattern canceled.
KSNA PWE
MUSEL LMN
HEMET BURKK
TRM HP BDF
EED* GSH
TBC KDTW
FMN *****
PUB
HLC
DIRECT 1/2
>
>
>
>
<
<
<
<
<
Figure 3-89
AT BDF
DIRECT ENTRY
INBOUND CRS 070
MAX HOLDING TAS 261
TURN DIR RIGHT
LEG TIME 1.5
LEG DIS (0.0)
EXIT MODE MANUAL
OK? ENTER CANCEL
HOLDING PATTERN 1/1
>
>
>
>
>
Figure 3-90