EasyManua.ls Logo

Honeywell GNS-XLS - Sensor Deselection

Honeywell GNS-XLS
415 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Operation
3-121
GNS-XLS Flight Management System
Rev. 3
Sep/96
b. BACK Key - DEPRESS. RESTORE? will appear to inform the
pilot of the pending change.
c. ENTER Key - DEPRESS to restore the station.
SENSOR DESELECTION
The deselection of a position sensor on NAVIGATION Page 4 com-
pletely eliminates the sensor’s contribution to the composite (blended)
position. This is only recommended if the pilot can determine which
position keeping sensor is inaccurate or by flying over a known location
and then comparing the sensor position against the known position.
To Deselect a Sensor:
1. NAV Key - DEPRESS until NAVIGATION Page 4 is displayed.
2. Line Select Key - DEPRESS to position the cursor over sensor to
be deselected.
3. BACK Key - DEPRESS.
OUT? will appear to
inform the pilot of the
pending change. (Figure
3-193)
4. ENTER Key -
DEPRESS. “OUT” will
remain in the sensor field
and “DESELECTED”
appears beside the cor-
responding sensor on the
SENSOR MESSAGES Page.
To Restore a Sensor:
a. NAV Key - DEPRESS to display NAVIGATION Page 4.
b. Line Select Key - DEPRESS to position cursor over sensor to
be restored.
c. BACK Key - DEPRESS. IN? appears to inform the pilot of
the pending change.
d. ENTER Key - DEPRESS to restore the sensor.
NOTE: If GPS is deselected, the remaining sensor radial error fields
will turn from yellow to green, indicating that those sensors are now
contributing to the composite position. Under normal circumstances,
IDENT ------
POS N 33 43.33
W116 54.37
VLF ? OUT? VPU 0.0
IRS 0.2 GPS 0.1
NAVIGATION 4/4
<
>
>
>
>
Figure 3-193

Table of Contents

Related product manuals