Honeywell GNS-XLS - Direct to - Random Waypoint

System Operation
3-53
GNS-XLS Flight Management System
Rev. 3
Sep/96
DIRECT TO - RANDOM WAYPOINT
This procedure enables the pilot to add a random waypoint to the
ACTIVE FLIGHT PLAN in the desired sequence and proceed direct
to it.
1. d Key - DEPRESS. The cursor will automatically appear over
the current TO waypoint on the DIRECT TO Page.
2. Line Select Key -
DEPRESS to position
the cursor over the iden-
tifier to follow the new
entry. (Figure 3-91)
3. Type in the waypoint
identifier.
4. ENTER Key - DEPRESS.
5. Waypoint Page
Coordinates - VERIFY or
INSERT. To insert
Waypoint Coordinates (cursor over POS field):
a. Latitude - INSERT (N or S first, then degrees, minutes and
hundredths (6 characters)).
b. ENTER Key - DEPRESS.
c. Longitude - INSERT (E or W first, then degrees, minutes and
hundredths (7 characters)).
6. ENTER Key - DEPRESS.
7. Waypoint Sequence -
VERIFY that the way-
point is in the proper
location. (Figure 3-92)
8. ENTER Key - DEPRESS.
Display automatically
advances to NAVIGA-
TION Page 1.
NOTE: If Direct To a pilot
entered waypoint is desired,
a latitude and longitude entry
may be required.
KSNA PWE
MUSEL LMN
HEMET BURKK
TRM HP BDF
EED* GSH
TBC KDTW
FMN *****
TO PUB
HLC
DIRECT 1/2
>
>
>
>
<
<
<
<
<
Figure 3-91
KSNA HLC
MUSEL PWE
HEMET LMN
TRM BURKK
EED* BDF
TBC TO ALS
FMN KDTW
PUB *****
DIRECT 1/2
>
>
>
>
<
<
<
<
<
>
Figure 3-92