Honeywell MAXPRO - Page 177

. . . . .
MAXPRO NVR WEB CLIENT
Introducing Web Client
MAXPRO NVR 3.1 Operator’s Guide 177
Note: The Web Server and MAXPRO Server are both installed on the NVR server
machine by default and the IPs are set by default to local IP or computer/machine
name. It is recommended to change these settings to NVR Server (local)
computer/machine name, if it is not set by default in your system. For Honeywell
supplied NVR boxes, default computer/machine name is MAXPRO-NVR and can
be updated in the configuration from the tool.
• Web Server IP: If the MAXPRO NVR server computer/machine name or IP (as
applicable) is changed then you should change the Web Server IP. Type the new
computer/machine name or IP (as applicable) in this box and then click Update.
• MAXPRO Server IP: If the MAXPRO NVR server computer/machine name or IP (as
applicable) is changed then you should change the MAXPRO Server IP. Type the
new computer/machine name or IP (as applicable) in this box and then click Update.
Note: Both Web Server IP and MAXPRO Server IP should be same.
7. Under Port Change:
• Http Port: If you want to change the http default port 80 to some other port number
then type the required port number and click Apply.
• Https Port: If you want to change the https default port 443 to some other port
number then type the required port number and click Apply.
Note: Port change option in the configurator tool is available only in 3.1 Build 65 Rev C
or higher version.
8. Click to close the MaxproWebConfigurator.