CONFIGURING MAXPRO NVR
Configuring the Cameras
92 MAXPRO NVR 3.1 Operator’s Guide
4
Note: For the streamers other than FishEye, the Enable Panorama options are not
visible.
• Select the Mounting Position. The available options are Wall, Ceiling and Ground.
• Select the Modes. The available options are VCam, Panorama, Panorama Wide,
and Panorama Narrow.
Note: The Mounting Position and Modes are common to both the Halocam and
Evolution cameras.
5. Click Save.
Image Stream Combinations for Oncam Grandeye Cameras
Each Halocam and Evolution camera works best when configured with a particular resolution
and fps. See Appendix , Image Stream Combinations for Oncam Grandeye Cameras section
for the optimum resolution and fps configurations for each of the cameras.
Viewing Live Video from Oncam Grandeye Cameras
See Video Viewing Options from Oncam Grandeye Cameras section.
Device Characteristics of Oncam Grandeye Cameras
See Appendix , Device Characteristics of Oncam Grandeye Cameras section.
Adding Axis 360/180 Camera
To add Axis 360/180 Camera in MAXPRO NVR
Note: v3.1 SP1 or later supports discovering and adding Axis 360/180 models. These
were supported through RTSP only in v3.1 or lower versions.
1. In MAXPRO NVR, click the Configurator tab. The System page displays by default.
2. Click the Camera tab to open the Camera page.
3. Under Discover cameras here
• Click to discover the cameras in the network. By default, the check boxes
corresponding to all the discovered cameras are selected.
To Next Page
Loading...
Need help?
General
