Honeywell MAXPRO - Editing the Ports

. . . . .
LOGGING ON AND FAMILIARIZATION
Logging on Using Profiles
MAXPRO NVR 3.1 Operator’s Guide 45
5. Click OK. The profile is deleted.
Editing the Ports
The MAXPRO NVR user interface includes a provision to modify the port number associated
to the following components:
•Trinity Server
• Trinity Controller
• NeoEngine Server
To e d i t t h e p o r ts
1. In the Server Settings dialog box, click Edit Ports. The port numbers associated to Server
IP/Name, Controller IP/Name and Storage Engine IP/Name are enabled for editing.
Figure 3-4 Editing the Ports
2. Change the port numbers as applicable.
3. Click Save.
Note: Port 20000 is used for ONVIF discovery.