. . . . .
CONFIGURING MAXPRO NVR
Configuring the Cameras
MAXPRO NVR 3.1 Operator’s Guide 101
Note: For Analog cameras, motion detection is only supported through Smart (Server)
VMD. For further details on options and steps for configuring Motion based
recording, see Appendix A, VMD Settings and Motion-based Recording
Configuration section.
• Video Channel Number - Specify the physical slot number of the analog capture
card.
Note: Based on the Analog Capture Card model, system will prompt a message to add
all supported channels by default. Click Yes to add all supported channels or No
to add only 1 channel.
4. Click to open the Camera Advanced Settings pane.
Figure 4-26 Camera Advanced Settings pane
Note: The Camera Advanced Settings pane is disabled when there are no cameras
available in the system.
To Next Page
Loading...
