. . . . .
CONFIGURING MAXPRO NVR
Configuring the System Settings
MAXPRO NVR 3.1 Operator’s Guide 69
Configuring the System Settings
The System settings enable in configuring the following:
• General System Settings
• Event Recording Settings
• Email Settings
• Holiday/Exception Settings for Schedules
To configure the system settings
•Click the Configurator tab. The System page appears by default.
Figure 4-1 System page
General System Settings
The general settings enable configuring of the device address, device name, and device
description for MAXPRO NVR.
To configure the general system settings
1. Under General Settings
•The Device Address displays by default. You can type a new device address as
applicable.
•The Device Name displays by default. You can type a new device name as
applicable.
•The Description of the device displays by default. You can type a new description as
applicable.
Note: The information in the Device Address and the Device Name fields is
mandatory. Device Address must be set to the machine name or IP address of
the NVR for the system to work properly.
To Next Page
Loading...
Need help?
General
