CONFIGURING MAXPRO NVR
Configuring the Disk Management Settings
72 MAXPRO NVR 3.1 Operator’s Guide
4
Configuring the Disk Management Settings
Disk Management helps you to configure the disk settings for saving the recorded video. All
the drives available on the MAXPRO NVR system are automatically added in the Disk
Management page.
To configure the Disk Management settings
1. Click the Configurator tab. The System page displays by default.
2. Click the Disk tab to open the Disk Management page.
Figure 4-2 Disk Management page
All the drives available on the MAXPRO
NVR system are listed.
Note: By default, the check boxes corresponding to all the drives except C:\ are selected.
C:\ is reserved for the Operating System data.
Caution: It is recommended that you do not choose the operating system drive for
saving the camera recordings (as a video storage drive). Selecting an
Operating System drive for video storage can lead to system instability.
3. The following information displays under Disk Management.
• Drive Name - displays the drive name such as C:\, D:\ and so on.
• Drive Type - displays the drive type (Fixed or Network).
To Next Page
Loading...
Need help?
General
