. . . . .
CONFIGURING MAXPRO NVR
Configuring the Cameras
MAXPRO NVR 3.1 Operator’s Guide 95
Note: Depending on the mounting position, the Axis 360/180 camera supports eight or
less video streams with one stream per channel added. Each channel added
consumes 1 channel license.
By default, the Axis 360/180 camera adds eight channels under camera list
covering below views. Views which are not required for your specific application
can be deleted. To reclaim the used channel license, select the specific channel
in the list and then click Delete.
1. Overview: A non-dewarped 360° view
2. Panorama: One dewarped 180° panoramic view
3. Double Panorama: Two dewarped 180° panoramic views (Not available when
the camera is mounted on a wall)
4. Quad View: Four dewarped 90° views, one for each direction (Not available
when the camera is mounted on a wall)
5. View Area 1: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
6. View Area 2: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
7. View Area 3: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
8. View Area 4: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
Adding Arecont 360/180 Camera
To add Arecont 360/180 Camera in MAXPRO NVR
Note: v3.1 SP1 or later supports discovering and adding Arecont 360/180 model
cameras. These were supported through RTSP only in v3.1 or lower versions.
1. In MAXPRO NVR, click the Configurator tab. The System page displays by default.
2. Click the Camera tab to open the Camera page.
3. Under Discover cameras here
• Click to discover the cameras in the network. By default, the check boxes
corresponding to all the discovered cameras are selected.
4. After the discovery, to add the Arecont 360/180 camera models, first clear the check
boxes corresponding to all other cameras other than Arecont 360/180 camera models as
shown below.
Note: Arecont 360/180 cameras are listed in the discovery pane with their model
numbers for example AV8365DN-F8.
To Next Page
Loading...
Need help?
General
