CONFIGURING MAXPRO NVR
Configuring the Cameras
88 MAXPRO NVR 3.1 Operator’s Guide
4
4. The Output(s) pane lists the outputs for the configured cameras. Select the appropriate
options in the fields as explained in the following table.
5. In the Output(s) pane, select an output and then click On to turn on the relay manually or
Click Off to turn off the relay manually.
6. Click Save or click Reset to undo the changes.
Send Alarm Monitor
(NO/YES)
The default option is No. If set to YES, video will pop up
in the viewer when an input is activated. Ensure that
"Display Video on Alarm" check box is selected in the
MAXPRO NVR Logon dialog box.
Field Description
Field Description
Output Number Control output number.
Name Control output name.
State
(CLOSED/OPEN)
The default option is OPEN.
Defines the normal (non-alarm or non-active) state of the output
relay contacts.
Camera Displays the associated camera name.
ON/OFF Manual control of the output. Click ON to close the relay
contacts. Click OFF to open the relay contacts.
To Next Page
Loading...
