I
-
Using Instrument Functions
Connecting and Configuring Printers and Plotters
The analyzer can send print commands in
PCL5,
PCL, Epson, or HP-GL
modes. Recommended usages are:
l
Use
PCL5
mode for
maximum
speed, if your printer supports it.
HP LaserJet
III/4/5
models support
PCL5.
Typical time to generate and
send hardcopy output to a
PCL5
printer is 1 to 10 seconds.
l
Use PCL or Epson language if your printer does not support
PCL5.
The
analyzer uses Epson ESC
Pl
commands that are common to
IBM
mode
devices and
FX-86e/FX-800
mode Epson compatible devices.
l
Use HP-GL language for plotters.
4-83
-
To Next Page
Loading...
