I
-
I
-
Selecting a Device
Configuring the
Analyzer for HP-IB
Devices
Configuring the
Analyzer for a LAN
Printer (Option
lF7
only)
Configuring the
Analyzer for RS.232
Devices
Using Instrument Functions
Connecting and Configuring Printers and Plotters
Press (HARD COPY]
Saleet
Copy
PM%
and turn the front panel knob to
move the highlighted bar to your printing or plotting device, then press
S*lact
.
If your
HP-II3
printing/plotting device has a different address than the
analyzer default of 05, press
Prtit/PlH
HP-18
Addr
and enter
the address of your printing/plotting device (typical factory defaults:
printer
=
01, plotter = 05). Use the front panel numeric key pad to make
your entry.
Press LAB
Prints
fP
Addr . Use an external keyboard connected to the
analyzer’s rear panel DIN KEYBOARD connector and type in the LAN IP
address. (For information on using a keyboard, see “Using a Keyboard” later
in this chapter.) Or use the front panel knob and
Sel~t;
Ghmacter
key
to point to and select each character of the IP address. Then press I&MT .
Refer to the User’s Guide Supplement
for
Option lF’7 for information on
using the LAN connection for printing.
1. If the baud rate of your printing/plotting device is different than the
factory default
(19200)
press
Baudl
R&o and enter the baud rate of your
printing/plotting device. (Refer to your printer or plotter manual for the
baud rate of your device.) You can set the baud rate to 1200, 2400, 4800,
9600, 19200 , 38400, 57600, or 115200 baud. If you are sending graphics
to the hardcopy device, the fastest supported baud rate is recommended.
2. Choose between
Xon/Xoff
(the default:
specifies
a software handshake)
and
DTR/DSR
(specihes
a hardware handshake).
4-84
To Next Page
Loading...
Need help?
General
