-
H
I
-
(HARDKEY)
I
SOftkq
Reference
H
Hardkey
in the SYSTEM area of the front panel. Displays the menu to start
or stop prints or plots, set up the printer or plotter, and determine the
appearance of the copy.
See “Connecting and
Conhguring
Printers and Plotters” and “Printing and
Plotting Measurement Results” in Chapter 4 for more information.
Softkey
in operating parameters menu. Dumps all of the operating parameter
screens to the currently selected hard copy device.
Access Keys:
(
SYSTEM OPTIONS
)
Operating
Pa;Fametsrs-
Softkey
in operating parameters menu. Dumps the currently viewed
operating parameter screen to the currently selected hard copy device.
Access Keys: [SYSTEM OPTIONS]
Operating
Par@iW@rs
Softkey
in update correction constants menu. Displays the help message that
describes the actions of the other
softkeys
in the update correction constants
menu.
Access Keys: (SYSTEM OPTIONS)
Service
Updats
Ckm?
Ganst
Softkey
in trigger menu. Stops the current data trace sweep immediately and
holds the sweep until
Contirmou~
or
Single
is selected.
Access Keys:
[MENU)
TIY~~W
Softkey
in more CRT adjustment menu. CRT timing adjustment for use with
external monitors. Also affects network analyzer’s internal CRT. Default
setting is 3.68 psec. This setting is not affected by an instrument preset.
See “Using an External VGA Monitor” in Chapter 4 for more information.
Access Keys:
(
SYSTEM
OPTIONS~
System
&mf
ig
CRT
Adjust
MWW
9-33
-1
I-
To Next Page
Loading...
