I
-
I
-
(jjj
I
Softkey
Reference
H
Horizontal
Softkey
in more CRT adjustment menu. CRT timing adjustment for use with
Frnt
Porch
external monitors. Also affects network analyzer’s internal CRT. Default
setting is 31.68
psec.
This setting is not affected by an instrument preset.
See “Using an External VGA Monitor” in Chapter 4 for more information.
Access Keys:
CSYSTEM
OPTIONS] System
Curtfig
CRT
Adjust
#ore
Softkey
in the CRT adjustment menu. Changes the horizontal positioning of
the display on both the internal CRT and an external monitor. Accepts whole
number values from 1 to 100, with 1 representing as far left as possible and
with 100 representing as far right as possible. The default value set at the
factory (and obtained by pressing
Roetore
Def&uI%s) is 73. This setting is
not affected by an instrument preset.
See “Using an External VGA Monitor” in Chapter 4 for more information on
using an external display.
Access Keys: (SYSTEM OPTIONS_)
Syst;em
Config
CRT
Adjus%
HN[p
BTIIJA/B
Softkey
in file format menu. Select this key only if you are saving instrument
Csmpatiblie
states that are to be used in older model (“A” or “B”) analyzers.
See “Saving and Recalling Measurement Results” in Chapter 4 for more
information.
Access Keys: (SAVE RECALL] Define Save File
Falrmat
H1?
87lic
Softkey
in file format menu. Always select this key, unless you need your
CompatibPe
saved file to be compatible with older model (“A” or
“B”)
analyzers.
See “Saving and Recalling Measurement Results” in Chapter 4 for more
information.
Access Keys:
CSAVE
RECALL]
I&fine
Save
Fils
Porna%
9-34
To Next Page
Loading...
