I
-
I
-
(j-j
I
SoftkBy Reference
S
Medium Wide
ldefaultl
Dynamic Range
LOW
Medium
Medium
Medium
High
High
Sweep
Speed
Fastest
Faster
Fast
Slow
Slower
Slowest
Approximate BW
6500 Hz
4000 Hz
3700
Hz
1200 Hz
250 Hz
15 Hz
System
Softkey
in [SYSTEM OPTIONS) menu.
Displays menu to adjust clock setting, set
beeper volume, adjust CRT settings, and configure the rear panel USER TTL
Cunffg
IN/OUT port.
Systea
Softkey
in HP-IB menu.
Makes the network analyzer the system controller of
the HP instrument bus. Required mode for interfacing with
HP-IR
peripherals
CuntroXLar
(printers plott
ens,
and disk drives). Also required by
IBASIC
to talk to HP-IB
peripherals. This operation mode is not selectable with another active
controller on the bus.
See the Programmer’s Guide for more information.
Access Keys: (SYSTEM OPTIONS]
HP-I3
(SYSTEM
OPTIONS)
Hardkey
in SYSTEM area of front panel.
System
Z(j
Softkey
in the
cal
kit menu.
Provides access to the system impedance menu.
Refer to “When to Change the System Impedance” in Chapter 3 for more
information.
Access Keys:
(CALI
Mox~
Cal
Ca‘L
Kit
9-80
-1
-
To Next Page
Loading...
