I
-
I
-
(jWj
I
Softkey
Reference
S
sweep
T&e
Softkey
in
CSWEEP)
menu.
Sets the sweep time from fastest possible to three
days (259.2 ks); overrides auto sweep time. Fastest possible sweeptime
varies, and depends on other analyzer settings.
See Chapter 5, “Optimizing Measurements” for more information on sweep
time.
S,q@sp
T$ae
Softkey
in
[SWEEP]
menu.
Sets the network analyzer to sweep as fast as
AUTO
miut
possible (automatic) or at the sweep time of your choice (manual).
See Chapter 5, “Optimizing Measurements” for more information on sweep
time.
Switching
Softkey
in the system
config
menu. For use with a muliport test set.
Test
Set
Refer to the multiport test set User’s and
Serwice
Guide for more information.
Access Keys: [SYSTEM OPTIONS] System
Cwfig
SWR
Softkey
in
@YGEJ
menu. Displays the data formatted as SWR (standing
wave ratio).
Sync
&~$en
Softkey
in CRT adjust menu. Default is OFF. For use with a sync-on-green
on
OFF
external monitor.
AccessKeys:
CSYSTEM
OPTIONS)
Systant
Cardig
CRT Adjust;
syst%m
Softkey
in the
m
menu.
Displays menu to set bandwidth of IF’ filters in
Bandwidth
receiver section of network analyzer.
See
“To
Reduce the Receiver Noise Floor” and the table below for more
information on system bandwidth.
9-79
-1
I-
To Next Page
Loading...
