I
-
I
-
(jHARDKEY)
I
SoPtkey
Reference
s
Stop
Softkey
in
(FREQI
menu. Sets the stop frequency of source. Maximum
frequency is 1.3
GHz
for HP
8712C
and 3.0
GHz
for HP
8714C.
Stop
Softkey
in
t-1
menu. Sets stopping point (in
dRm)
for a power sweep
power
measurement.
Pcr=#~
SwoeesP
in
@iYLFF]
menu must be selected before
setting the start and stop power points.
See
Pox~er
Sweep
entry in this chapter for more information on the power
sweep function.
Storg
Cc
Softkey
in update correction constants menu. Writes a copy of CC data from
To Disk
internal volatile RAM to a disk in the analyzer’s built in 3.5” disk drive. This
function is used to make a backup copy of CC data.
See the Service
Guide
for more information.
Access Keys: [SYSTEM OPTIONS)
Updats
Ccrrr
Const
StoJr@
cc
Softkey
in update correction constants menu. Writes a copy of CC data from
To
EPROM
internal volatile RAM to EPROM. This function is used so that current CC
data is not lost when power to the analyzer is turned off.
See the Service Guide for more information.
Access Keys: (SYSTEM OPTIONS] Up&&.e
Curr
Con&t
[%j
Hardkey
in SOURCE area of front panel. Displays menu to select automatic
sweep tune (fastest possible), manual sweep, alternate sweep, or power
sweep.
Sweep
&it
Softkey
in user TTL
config
menu.
Sets the USER TTL IN/OUT port on the
rear panel to be pulled high during a sweep.
Access Keys: (SYSTEM OPTIONS)
Syster!r
&xxfig
User
?TL
Gotiig
9-78
I-
To Next Page
Loading...
