Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100)
* Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(VtUtf8)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(PcAnsi)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100)
* Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(VtUtf8)
* Indicates a currently selected device.
• Each option is identified with an EFI Device path. Not all options will be available, depending
on the configuration of the system and the options available. Device paths can differ slightly
on different product models.
• On both serial device examples, UART 9600 indicates the current baud rate of the serial
device, VenMsg Vt100+ is the current emulation type. Several different terminal emulation
protocols are supported.
• Only one terminal emulation type (PcAnsi, Vt100, and so on) can be selected for each serial
console, but multiple serial consoles can be selected at once.
Table 94 Console Input Devices
SelectDevice
Acpi(PNP0501,0)/Uart(9600 N81)/VenMsg(Vt100+)Serial A/Serial 1
Acpi(HWP0002,700)/Pci(1|1)/Uart(9600 N81)/VenMsg(Vt100+)iLO 2 MP Serial Console
Select Active Standard Error Devices
Use this option to define the devices that display error messages from the system console.
This menu is identical to the Console Output Devices menu. The server does not support different
configurations for Output and Error console. When you make changes to either Output or Error
console menus, you must make the identical change in the other menu. When you change serial
devices, you must make changes to Output, Input, and Error menus for proper operation
Using the System Configuration Menu
The System Configuration Menu on systems with EFI firmware version 2.0 or higher includes the
following options:
• Security/Password Menu: Enables you to change the administrator and user passwords.
• Advanced System Information Menu: Displays information about system and component
configuration.
• Set System Date: Enables you to modify the system date.
• Set System Time: Enables you to modify the system time.
• Reset Configuration to Default: Enables you restore system settings to their original configuration.
• Help: Displays additional information about the available options.
• Exit: Returns to the EFI startup menu.
Security/Password Menu
You can set administrator and user passwords to provide different levels of access to the system
firmware.
Resetting Passwords
If you forget your passwords, reset them by running using the iLO 2 MP <Ctrl+N>rs command.
This command resets the iLO 2 MP and resets the password.
NOTE: You can only run this command when directly connected to the server.
Using the Boot Option Maintenance Menu 341
To Next Page
Loading...
Need help?
General
