15. At the EFI Shell prompt, enter the following command:
Shell> reset
The system starts to reboot. This is required to enable the new SCSI setting.
Using the Boot Option Maintenance Menu
This menu enables you to select console output and input devices as well as various boot options.
It contains the following options:
• “Boot From a File” (page 336)
• “Add a Boot Option” (page 337)
• “Delete Boot Option(s)” (page 338)
• “Change Boot Order” (page 338)
• “Manage BootNext Setting” (page 339)
• “Set Auto Boot TimeOut” (page 339)
• “Select Active Console Output Devices” (page 339)
• “Select Active Console Input Devices” (page 340)
• “Select Active Standard Error Devices” (page 341)
• “Security/Password Menu” (page 341)
• “Resetting Passwords” (page 341)
These options are described in the following sections.
The following selections are available on all menus:
• Help: Displays the help available for the command.
• Exit: Returns to the main Boot Options Maintenance menu.
• Enter: Selects an item after using the arrow keys to highlight the item.
• Save Settings to NVRAM: Saves your changes.
NOTE: The options shown here are examples. Your system may have different options available
based on the system configuration and installed hardware components.
Paths
All devices in the server are represented by paths in the EFI Shell. To identify the correct socket or
disk drive, use the following tables.
Table 91 Server Sockets
PathSocket
Acpi(HWP0002,400)/pci(0|0)1 PCI
Acpi(HWP0003,400)/pci(0|0)2 PCI
Table 92 Server Drives
PathDrive
Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)SCSI Disk
Acpi(HWP0002,100)/Pci(1|1)/Scsi(Pun0,Lun1)SCSI Disk
Acpi(HWP0002,0)/Pci(2|0)/ATA(Primary,Master)Removable Media Boot
Boot From a File
Use this option to manually run a specific application or driver.
336 Utilities
To Next Page
Loading...
Need help?
General
