HP Integrity rx6600 Service Manual

Figure 15 LAN Link and Status LEDs
Power Supply
The server can have one or two power supplies, labeled PS0 and PS1. Each power supply has an
AC input receptacle and an LED that shows the power state of the server (Figure 13).
The server has three power states: standby power, full power, and off. Plug the power cord into
the appropriate receptacle on the rear of the chassis to achieve the standby power state. To bring
the server to full power plug the power cord into the appropriate receptacle, and either activate
the power using the iLO 2 MP PC command, or push the Power button. To bring the server to the
off state, unplug the power cords.
Table 12 lists the power supply LED states.
Table 12 Power Supply LED
Power Supply ConditionPower Supply LED
No AC powerOff
AC power; standby power onBlinking green
Full power on; normal operationSolid green
Power supply failureBlinking amber
Figure 16 shows the power LEDs.
Controls, Ports, and LEDs 37

HP Integrity rx6600 Specifications

General

Processor	Intel Itanium 2
Network	Integrated dual Gigabit Ethernet
Form Factor	5U rack-mountable
Power Supply	Redundant hot-plug power supplies
Processor Speed	1.6 GHz
Memory Type	DDR2 ECC Registered
RAID Support	Yes
Operating System	HP-UX, Linux, Windows Server