saupdate ?
Error Messages
The following is a list of error messages under various situations:
• When keyword LIST or UPDATE is misspelled or extra parameters are specified:
Error: Syntax Error
Usage: saupdate LIST or saupdate UPDATE [ all ]
• When the controller ID in the saupdate UPDATE command is not correct:
No matching controller found
• When a firmware file does not exist in the saupdate UPDATE command, the example shows:
CYBORG101.BIN does not exist.
File CYBORG101.BIN: Not Found
• When an invalid firmware or corrupted file is specified in the saupdate UPDATE command,
the example shows: CYBORG101.BIN does not exist.
File CYBORG101.BIN: invalid or corrupted
EBSU Utility
The EFI-based Setup Utility (EBSU) provides an easy-to-use interface for flashing firmware, partitioning
the hard disk, installing diagnostic tools, configuring storage controllers, and running other EFI
utilities.
NOTE: You can use EBSU to update firmware for many different devices in the system. Smart
Array P600 is shown as an example.
To update the Smart Array firmware:
1. Power on the server. The server boots to EFI. The EFI Boot Manager may be used from the
enhanced interface (grey background) or the legacy interface (black background).
2. Load the HP Smart Setup media into the server DVD drive.
3. From the EFI Boot Menu, select Internal Bootable DVD and press Enter. EBSU starts and displays
the Welcome screen.
Figure 96 EBSU Welcome Screen
304 Core I/O Card Utilities
To Next Page
Loading...
