To ensure you have the latest version of the firmware running on the server, download the latest
version of the firmware from the web, and create a CD to install the firmware on the server.
Downloading the Latest Version of the Firmware
To download the latest version of the firmware from the web, follow these steps:
1. Go to http://www.hp.com/go/bizsupport.
2. Select download drivers and software.
3. Select Itanium-based servers from the Server category.
4. Select your server from the servers listed.
5. Select your operating system.
6. Select the firmware category you want to download.
7. Download the firmware to a CD.
Installing the Latest Version of the Firmware on the Server
To install the latest version of the firmware on the server, follow these steps:
1. Start a server console session. See Section : “Console Setup” (page 77).
2. Insert the CD with the copy of the latest version of the firmware.
3. Using the EFI Boot Manager menu, boot to the drive that contains the CD with the updated
firmware.
4. Follow the instructions to update the firmware.
Enabling the Trusted Platform Module
This section provides instructions on how to enable the trusted platform module (TPM).
Introduction
The TPM is an optional security component which enhances security capabilities for the server if
it is running the HP-UX operating system. The TPM is a security chip that is unique to the server. It
performs key security processes independent of other hardware components. The TPM creates and
stores additional encryption keys from the root key of the system. The encryption keys created by
the TPM encapsulate system application encryption keys to provide an additional layer of security
for sensitive system data.
The fundamental capabilities of the TPM include:
• Platform authentication
• Sensitive information protection
• Data integrity
• System privacy
IMPORTANT: You must run the supported version of the HP-UX operating system to utilize the
TPM security component.
WARNING! Ensure that the system is powered off and all power sources have been disconnected
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions can result in damage to the server.
116 Installing the System
To Next Page
Loading...
Need help?
General
