8. Install the DIMM (Figure 71).
a. Align the DIMM with the correct slot on the memory board, and align the key in the
connector with the notch in the DIMM.
b. Firmly and evenly push on each end of the DIMM until it seats into the slot.
c. Ensure the extraction levers are in the locked position.
Figure 71 Inserting DIMM into Memory Board Connector
9. Replace the memory carrier assembly side cover.
a. Insert the side cover tabs into the retaining slots at the base of the assembly (Figure 69).
b. Insert the tabs (Figure 68) into the slots on both sides of the extraction handle release
button until the side cover snaps into place.
NOTE: To install DIMMs into slots on the other side of the memory carrier, turn the carrier
over to the opposite side (side 0 or side 1) and repeat the installation procedure.
10. Replace the memory carrier assembly and latch the top cover release lever closed. See
“Replacing the Memory Carrier Assembly” (page 204).
11. If rack installed, slide the server completely into the rack. See “Inserting the Server into the
Rack” (page 177).
12. Reconnect the power cables and power on the server. See “Powering On the Server” (page 90).
Removing and Replacing the Front Bezel
The front bezel provides server control and port access, and LED interfaces. You must power off
the server to remove the front bezel.
212 Removing and Replacing Server Components
To Next Page
Loading...
Need help?
General
