Example 12 conconfig 2 primary command
To change primary operating system console
Shell> conconfig 2 primary
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1)
3 S VGA Acpi(HWP0002,0)/Pci(4 0)
Example 13 conconfig 3 off command
To disable a console
Shell> conconfig 3 off
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1
3 NC VGA Acpi(HWP0002,0)/Pci(4 0)
Example 14 conconfig 3 on command
To enable a console
Shell> conconfig 3 on
CONSOLE CONFIGURATION
Index Status Type Device Path
----- ------ ---- -----------
1 NC Serial Acpi(PNP0501,0)
2 P Serial Acpi(HWP0002,0)/Pci(1 1)
3 S VGA Acpi(HWP0002,0)/Pci(4 0)
ioconfig
Use this command to deconfigure or reconfigure I/O components or settings.
Syntax
ioconfig <fast_init | mps_optimize | wol> <on | off>
Parameters
<fast_init> specifies device connection policy setting
<mps_optimize> specifies PCIe MPS optimization setting
<wol> specifies system wake-on-lan setting
<on | off> specifies to configure or deconfigure a feature or component
Operation
The ioconfig file is used to retain information on system's I/O configuration across reboots. The
ioconfig file is created by insf at install time; and is modified by insf, rmsf, and ioscan
when devices are added or removed. The only purpose of the ioconfig file is to maintain
configuration information when the system is not running.
EFI/POSSE Commands 319
To Next Page
Loading...
