HP ProCurve 2650

6-5
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Inbound Telnet
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
Listing the Current Console/Serial Link Configuration. This com-
mand lists the current interface access parameter settings.
Syntax: show console
This example shows the switch’s default console/serial configuration.
Figure 6-2. Listing of Show Console Command
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax: [no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
show console below
[no] telnet-server below
[no] web-management page 6-6
console page 6-6
Interface Access
Enable/Disable
Console Control
Options
Event Log Event
Types To List
!Software.book Page 5 Thursday, October 10, 2002 6:10 PM