HP ProCurve 2650

6-16
Interface Access, System Information, and Friendly Port Names
Using Friendly (Optional) Port Names
■ To retain friendly port names across reboots, you must save the current
running-configuration to the startup-config file after entering the friendly
port names. (In the CLI, use the write memory command.)
Configuring Friendly Port Names
Syntax:interface [e] <port-list> name <port-name-string>Assigns a port name to
port-list.
no interface [e] <port-list> nameDeletes the port name from port-list.
Configuring a Single Port Name. Suppose that you have connected port
A3 on the switch to Bill Smith’s workstation, and want to assign Bill’s name
and workstation IP address (10.25.101.73) as a port name for port A3:
Figure 6-9. Example of Configuring a Friendly Port Name
!Software.book Page 16 Thursday, October 10, 2002 6:10 PM